OUR PRICE: $19.99
MSRP: $29.99
You save $25.49

Legion RDA Clone by Acerig

Add to Cart


OUR PRICE: $19.99
MSRP: $29.99
You save $25.49


SKU:940084 ,Availability: ,Width: ,Height: ,Depth:


Ships same day if order placed before 2:00 P.M. EST (except Sundays and Holidays)


This product does not carry any warranty and we only guarantee that you will not…


This product does not carry any warranty and we only guarantee that you will not receive it DOA (Dead on Arrival).


Legion RDA Clone by Acerig

The Legion RDA clone by Acerig was engineered with the Cloudchasers in mind. Its unique 3 post design has 2 large holes on each negative post which allows for a relatively easy way to do an 8 coil(Yes, 8!) build. The Legion is basically a one-man-army that will not disappoint the avid vaper. The extra deep well helps cut down on leakage and the two angled air holes are said to also create a vortex-like airflow for a more efficient draw. The adjustable copper 510 pin completes this full featured atty! Order today and take the Legion RDA into battle on your next cloud competition!

For best results, we recommend to wash the entire Atomizer before use. Price is for one (1) RDA.

Legion RDA Clone by Features

  • Stainless Steel Construction
  • Copper exterior on tube for aesthetics
  • Large post holes(approximately 3mm)
  • 3 post design: 1 positive(1 post hole)/2 negative(2 post holes on each)
  • Leads are tightened with Hex grub screws
  • Deep over-drip well(approximately 4.5mm)
  • Gladiator helmet styled cutouts on the sleeve
  • Heat-sink fins on the top cap
  • Threaded top cap can be separated from sleeve
  • Adjustable Airflow
  • Adjustable Copper Contact
  • 510 Connection
  • 22mm Diameter
  • 29mm Height

Box Contents

  • 1x Legion RDA Clone by Acerig
  • 9x Grub Screws
  • 1x Allen Key
  • 1x Spare O-Ring
  • 2x Pre-built Coils
  • 1x Japanese Cotton Pad

IMPORTANT NOTE: Rebuildable Dripping Atomizers ( RDA ) are for EXPERTS and ARE NOT recommended for average users or beginners.  The use and knowledge of how to properly test for shorts with a multimeter is a very important factor when building your own coils and wicks.  WE DO NOT OFFER ANY WARRANY, REFUNDS OR EXCHANGES ON ANY REBUILDABLE ATOMIZERS DUE TO THE NATURE OF THESE PRODUCTS.


  1. Wicks / Coils must be tested carefully with a multimeter before use.
  2. If Wick / Coil is not properly tested it will be a risk to the user to do so.
  3. Faulty Wicks / Coils WILL kill electronic devices.
  4. New Wick / Coil units must be tested and then used on a strong basic electrical APV / MOD that has short protection.
  5. No new Wick / Coil assembly should be used on an electronic device until it is known to be safe.
  6. These items destroy electronic devices if not properly built.  This is a known issue.

Customers Also Viewed