The Ripper Stack Mech MOD from Deathwish is the supercharged masterpiece engraved to perfection and ready for any competition foolish enough to stand against it. The solid metal chassis is sculpted to ideal standards perfect for superb conductivity and therefore, fantastic performance. The signature Deathwish firing switch works wonders under even the most demanding of conditions, pushing premium power to installed builds. The Ripper is designed specifically with 20650 cells in mind, but fear not—18650s are also compatible with the included delrin battery sleeves.
The Unholy v2 RDA is similarly innovative, utilizing a uniquely constructed build deck that uses a ball-bearing in each post to clamp down on inserted leads, much like the anvil posts of the SZX RDA. The two crossbones "X"-shaped slots—positioned on either side of the sleeve—provides liberal amounts of air to demanding builds.
*PLEASE NOTE THIS PRODUCT WILL ONLY SHIP TO A VERIFIED DOMESTIC BILLING ADDRESS (Your U.S. Credit Card Billing Address) & WILL REQUIRE A SIGNATURE AT DELIVERY. INTERNATIONAL CUSTOMERS MUST PAY BY BANK WIRE TRANSFER. INTERNATIONAL INQUIRIES CAN BE MADE >HERE<
Find Your Spares and Supplies Here:
The Ripper Stack 20650 Mech MOD
Unholy v2 RDA
**THIS DEVICE IS 8.4 VOLTS** This mechanical mod is wired in series, meaning that your maximum voltage (4.2V) will be multiplied by the number of battery cells in series, which does the same to your amperage load as well. As such, series mechanical mods require extensive knowledge and familiarity with both Ohm’s Law and battery safety/amp limits in order to be used without risk of damage to yourself or your surroundings. If you are at all unfamiliar with this subject, feel free to contact us and we’ll be happy to either provide additional information or suggest comparable alternatives, such as an unregulated device wired in parallel. Use this device with caution and at your OWN RISK. By purchasing this device, you agree that we are NOT liable for any damages due to misuse.
PLEASE NOTE: This is a direct battery contact mechanical device and it is strictly for ADVANCED USERS ONLY! Be sure to check your atomizer's 510 connection when using it with this device. If your atomizer's positive pin in the center of the 510 connection does not protrude >1mm from the threads of the connection, your device WILL fail catastrophically. Use at your own risk! This mod does not have a locking mechanism, so keep it away from children! Mechanical mods are an advanced user product and should not be used by anyone without the proper knowledge on your battery's amp limit and how to test your atomizer's resistance. This mechanical mod uses very strong magnets in the switch—please be careful when disassembling your mod. Avoid using your device to the point where the batteries are completely discharged. Always double-check the resistance of your atomizer on an external ohmmeter, and ensure that your batteries are inserted with the positive pole facing the atomizer in order to prevent battery failure.
IMPORTANT NOTE: Rebuildable Atomizers (RBAs, RDAs, etc.) are ADVANCED USER PRODUCTS and ARE NOT recommended for average users or beginners. The use and knowledge of how to properly test for shorts with a multimeter is a very important factor when building your own coils and wicks. WE DO NOT OFFER ANY WARRANTY, REFUNDS OR EXCHANGES ON ANY REBUILDABLE ATOMIZERS DUE TO THE NATURE OF THESE PRODUCTS.